Q. What is the steam economy in case of a single effect evaporator system ?

View solution

Q. If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length

View solution

Q. jH factor for heat transfer is not a function of the __________ number.

View solution

Q. The Fourier number (defined as a.t/L²) is used in the analysis of problem involving heat transfer by

View solution

Q. The energy radiated from a surface Q at absolute temperature T is related as

View solution

Q. A 2-4 heat exchanger involves

View solution

Q. In a liquid-liquid heat exchanger, for the same process temperature, the ratio of the LMTD in parallel flow to the LMTD in counter flow is always

View solution

Q. With increase in temperature, the thermal conductivity of steel

View solution

Q. Which of the following forced convection heat transfer equation accounts for the liquid viscosity effect for viscous liquids ?

View solution

Q. The main function of baffles provided in a shell and tube heat exchanger is to

View solution

Q. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a

View solution

Q. A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to

View solution

Q. Prandtl and Reynolds analogy are same, when Prandtl number is

View solution

Q. Heat transfer occurs by natural convection because change in temperature causes difference in

View solution

Q. The ratio of kinematic viscosity to thermal diffusivity is called the __________ number.

View solution

Q. Baffles are provided in heat exchangers to increase the

View solution

Q. 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10⁻³ kg/m².s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m²/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)

View solution

Q. In case of a vertical tube evaporator, with increase in the liquor level, the

View solution

Q. The ratio of total radiating power to the absorptivity of the body depends upon the __________ as per Kirchoffs law.

View solution

Q. For gases, the thermal conductivity increases with temperature rise. For liquids, with increase in concentration, its thermal conductivity generally

View solution