Q. Which of the following forced convection heat transfer equation accounts for the liquid viscosity effect for viscous liquids ?

View solution

Q. The main function of baffles provided in a shell and tube heat exchanger is to

View solution

Q. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a

View solution

Q. A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to

View solution

Q. Prandtl and Reynolds analogy are same, when Prandtl number is

View solution

Q. Heat transfer occurs by natural convection because change in temperature causes difference in

View solution

Q. The ratio of kinematic viscosity to thermal diffusivity is called the __________ number.

View solution

Q. Baffles are provided in heat exchangers to increase the

View solution

Q. 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10⁻³ kg/m².s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m²/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)

View solution

Q. In case of a vertical tube evaporator, with increase in the liquor level, the

View solution

Q. The ratio of total radiating power to the absorptivity of the body depends upon the __________ as per Kirchoffs law.

View solution

Q. For gases, the thermal conductivity increases with temperature rise. For liquids, with increase in concentration, its thermal conductivity generally

View solution

Q. Mechanical recompression evaporation is used in the production of

View solution

Q. A measure of the extent to which viscous heating is important relative to the heat flow resulting from the impressed temperature difference is represented by the __________ number.

View solution

Q. Out of 100 kcal/second of incident radiant energy on the surface of a thermally transparent body, 300 kcal/second is reflected back. If the transmissivity of the body is 0.25, the emissivity of the surface will be

View solution

Q. The purpose of providing a 'catchall' in the vapor line of an evaporator is to

View solution

Q. What is the thermal conductivity of a perfect heat insulator ?

View solution

Q. In a single effect evaporator, the economy is

View solution

Q. LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is

View solution

Q. Which of the following is not concerned with the heat transfer?

View solution