Q. LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is

View solution

Q. Which of the following is not concerned with the heat transfer?

View solution

Q. Latent heat absorbed by 1 lb of water at 212°F, when it is changed to steam at 212°F, may be around __________ BTU.

View solution

Q. In counter flow compared to parallel flow,

View solution

Q. The thermal radiative flux from a surface of emissivity = 0.4 is 22.68 kW/m². The approximate surface temperature (K) is (Stefan-Boltzman constant = 5.67x10⁻⁸ W/m².K⁴)

View solution

Q. Crystallisation of solids from a homogeneous solution is a/an __________ process.

View solution

Q. A multiple effect evaporator has a capacity to process 4000 kg of solid caustic soda per day, when it is concentrating from 10% to 25% solids. The water evaporated in kg per day is

View solution

Q. Value of Prandtl number for water ranges from

View solution

Q. Heat transfer in the laminar sublayer in case of a liquid flowing through a pipe, is mostly by

View solution

Q. In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.

View solution

Q. The local surface conductance for laminar film condensation on vertical surface is (where, t = film thickness)

View solution

Q. Heat transfer co-efficient (h₁) for liquids increases with

View solution

Q. A diathermaneous substance __________ the thermal radiation completely.

View solution

Q. A hot body will radiate heat most rapidly, if its surface is

View solution

Q. Evaporation of 1kg of water from a solution in a single effect evaporator requires about __________ kg of steam.

View solution

Q. A metal wire of 0.01 m dia and thermal conductivity 200 W/m.K is exposed to a fluid stream with a convective heat transfer coefficient of 100 W/m².K. The Biot number is

View solution

Q. Analogy between mass and heat transfer is not applicable in case of

View solution

Q. A __________ surface has the maximum thermal emissivity out of the following.

View solution

Q. Radiant energy received by a body is proportional to (where, d = the distance between the object emitting radiation and that receiving it.)

View solution

Q. Film boiling is usually not desired in commercial equipments, because

View solution