Q. Heat transfer in the laminar sublayer in case of a liquid flowing through a pipe, is mostly by

View solution

Q. In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.

View solution

Q. The local surface conductance for laminar film condensation on vertical surface is (where, t = film thickness)

View solution

Q. Heat transfer co-efficient (h₁) for liquids increases with

View solution

Q. A diathermaneous substance __________ the thermal radiation completely.

View solution

Q. A hot body will radiate heat most rapidly, if its surface is

View solution

Q. Evaporation of 1kg of water from a solution in a single effect evaporator requires about __________ kg of steam.

View solution

Q. A metal wire of 0.01 m dia and thermal conductivity 200 W/m.K is exposed to a fluid stream with a convective heat transfer coefficient of 100 W/m².K. The Biot number is

View solution

Q. Analogy between mass and heat transfer is not applicable in case of

View solution

Q. A __________ surface has the maximum thermal emissivity out of the following.

View solution

Q. Radiant energy received by a body is proportional to (where, d = the distance between the object emitting radiation and that receiving it.)

View solution

Q. Film boiling is usually not desired in commercial equipments, because

View solution

Q. For the same heat transfer area and the terminal conditions, the ratio of the capacities of a single effect evaporator to a triple effect evaporator is

View solution

Q. The variation of thermal conductivity of a metal with temperature is often correlated using an expression of the form K = K₀ + at. where, K is the thermal conductivity and T is the temperature (in °K). The units of 'a' in SI system will be

View solution

Q. Film condensation is promoted on a/an __________ surface.

View solution

Q. Dietus-Boelter equation cannot be used for molten metals mainly due to its very low

View solution

Q. If Prandtl number is greater than the Schmidt number, then the

View solution

Q. Which of the following accessories is provided in the vapor line of an evaporator for removing the entrained liquid ?

View solution

Q. Rate of heat transfer by vaporisation from pools of water is affected by the

View solution

Q. Multiple effect evaporators are commonly used in the manufacture of

P. Paper
Q. Superphosphate
R. Sugar
S. Fats

View solution