Q. Choose the correct equation.

View solution

Q. In a forward feed multiple effect evaporator unit

View solution

Q. In case of heat flow by conduction for a cylindrical body with an internal heat source, the nature of temperature distribution is

View solution

Q. For heat flow through very thick walled cylinder, use____mean radius.

View solution

Q. Indirect contact heat exchangers are preferred over direct contact heat exchangers, because

View solution

Q. In SI units, fouling factor is expressed in

View solution

Q. An ejector is used to

View solution

Q. Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the

View solution

Q. All analogy equations connecting friction factor and heat transfer co-efficient apply only to

View solution

Q. Electro-magnetic spectrum range, which is important for radiation varies from __________ microns.

View solution

Q. Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U2, then

View solution

Q. In SI units, thermal conductivity is expressed in

View solution

Q. Boiling point of a solution according to Duhring's rule is a linear function of the __________ of water.

View solution

Q. The overall resistance for heat transfer through a series of flat resistance, is the __________ of the resistances.

View solution

Q. At what value of Prandtl number, conduction is negligible in the turbulent core of a fluid flowing through a heated pipe ?

View solution

Q. A sphere of radius 'R1' is enclosed in a sphere of radius 'R2'. The view (or shape) factor for radiative heat transfer of the outer sphere with respect to the inner sphere is

View solution

Q. For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is

View solution

Q. The main purpose of providing fins on heat transfer surface is to increase the

View solution

Q. A BTU/hr.ft.² °F is equal to

View solution

Q. Which of the following has the lowest Prandtl number ?

View solution