Q. Electro-magnetic spectrum range, which is important for radiation varies from __________ microns.

View solution

Q. Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U2, then

View solution

Q. In SI units, thermal conductivity is expressed in

View solution

Q. Boiling point of a solution according to Duhring's rule is a linear function of the __________ of water.

View solution

Q. The overall resistance for heat transfer through a series of flat resistance, is the __________ of the resistances.

View solution

Q. At what value of Prandtl number, conduction is negligible in the turbulent core of a fluid flowing through a heated pipe ?

View solution

Q. A sphere of radius 'R1' is enclosed in a sphere of radius 'R2'. The view (or shape) factor for radiative heat transfer of the outer sphere with respect to the inner sphere is

View solution

Q. For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is

View solution

Q. The main purpose of providing fins on heat transfer surface is to increase the

View solution

Q. A BTU/hr.ft.² °F is equal to

View solution

Q. Which of the following has the lowest Prandtl number ?

View solution

Q. Choose the most important factor on which the heat conducted through a wall in a unit time will depend on ?

View solution

Q. Which of the following has the minimum thermal conductivity ?

View solution

Q. In a heat exchanger, one transfer unit means

View solution

Q. For condensation of pure vapors, if the heat transfer co-efficients in filmwise and drop-wise condensation are respectively hf and hd, then

View solution

Q. Pick out the wrong statement:

View solution

Q. The advantage of backward feed multiple effect evaporators over forward feed units is that

View solution

Q. Which of the following is the most controlling factor for the rate of bubble detachment from the hot solid surface ?

View solution

Q. Which characteristic of a fluid is not important in deciding its route in a shell and tube heat exchanger ?

View solution

Q. Thermal conductivities of most of the liquids __________ with rise in temperature.

View solution