Q. Pick out the wrong statement:

View solution

Q. The advantage of backward feed multiple effect evaporators over forward feed units is that

View solution

Q. Which of the following is the most controlling factor for the rate of bubble detachment from the hot solid surface ?

View solution

Q. Which characteristic of a fluid is not important in deciding its route in a shell and tube heat exchanger ?

View solution

Q. Thermal conductivities of most of the liquids __________ with rise in temperature.

View solution

Q. A metal ball of radius 0.1 m at a uniform temperature of 90°C is left in air at 30°C. The density and the specific heat of the metal are 3000 kg/m³ and 0.4 kJ/kg.K respectively. The heat transfer co-efficient is 50 W/m².K Neglecting the temperature gradients inside the ball, the time taken (in hours) for the ball to cool to 60°C is

View solution

Q. Intermittant tube cleaning is possible to be done in case of a __________ evaporator.

View solution

Q. Arithmetic mean area can be used in heat transfer problem to calculate the heat flow by conduction through a cylinder which is

View solution

Q. Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for

View solution

Q. Overall heat transfer co-efficient for cooling of hydrocarbons by water is about

View solution

Q. For concentrating an aqueous solution of a material like anhydrous Na₂SO₄, whose solubility decreases with rise in temperature, the most suitable evaporator is a __________ evaporator.

View solution

Q. Circulation pump is located below the evaporater to

View solution

Q. The statement that "maximum wavelength of radiation is inversly proportional to the temperature" is __________ law.

View solution

Q. Steam condensate is recovered by steam traps and recycled for use as boiler feed water, because of its low

View solution

Q. Duhring rule is important in solving problems on

View solution

Q. In a shell and tube heat exchanger, the height of 25 percent cut baffles is equal to (where, D = inside diameter of shell)

View solution

Q. Multiple effect evaporation is generally recommended, when the

View solution

Q. The inside heat transfer co-efficient in case of turbulent flow of liquid in the tube side in a 1-2 shell and tube heat exchanger is increased by __________ times, when the number of tube passes is increased to 8.

View solution

Q. __________ heat exchanger is the most suitable, when the temperature of shell side fluid is much higher than that of tube side.

View solution

Q. The rate of heat transfer from a vertical plate by natural convection depends upon the temperature differences (ΔT) between wall and outside bulk. The proportionality is given as

View solution