Q. Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for

View solution

Q. Overall heat transfer co-efficient for cooling of hydrocarbons by water is about

View solution

Q. For concentrating an aqueous solution of a material like anhydrous Na₂SO₄, whose solubility decreases with rise in temperature, the most suitable evaporator is a __________ evaporator.

View solution

Q. Circulation pump is located below the evaporater to

View solution

Q. The statement that "maximum wavelength of radiation is inversly proportional to the temperature" is __________ law.

View solution

Q. Steam condensate is recovered by steam traps and recycled for use as boiler feed water, because of its low

View solution

Q. Duhring rule is important in solving problems on

View solution

Q. In a shell and tube heat exchanger, the height of 25 percent cut baffles is equal to (where, D = inside diameter of shell)

View solution

Q. Multiple effect evaporation is generally recommended, when the

View solution

Q. The inside heat transfer co-efficient in case of turbulent flow of liquid in the tube side in a 1-2 shell and tube heat exchanger is increased by __________ times, when the number of tube passes is increased to 8.

View solution

Q. __________ heat exchanger is the most suitable, when the temperature of shell side fluid is much higher than that of tube side.

View solution

Q. The rate of heat transfer from a vertical plate by natural convection depends upon the temperature differences (ΔT) between wall and outside bulk. The proportionality is given as

View solution

Q. If air (a non-condensing gas) is present in a condensing vapor stream, it will __________ the condensation rate of vapor.

View solution

Q. Prandtl and Reynold's analogies are identical for Prandtl number value of

View solution

Q. The outlet temperature of cooling water in a heat exchanger is generally not allowed to exceed above 50°C in industrial practice mainly to avoid

View solution

Q. In evaporators, lowering the feed temperature

View solution

Q. Unsteady state heat conduction occurs, when

View solution

Q. What is the absorptivity of a black body ?

View solution

Q. Mode of heat transfer in which the fluid moves under the influence of changes in fluid pressure produced by external work is called

View solution

Q. Baffle spacing

View solution