Q. One kilogram of water at 0°C is changed to superheated steam of one atm pressure and 300° C. The major heat consumption in the process will be to

View solution

Q. The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe whose surface temperature remains constant is

View solution

Q. Sensible heat of hot industrial flue gases can not be recovered by a/an

View solution

Q. The critical radius of insulation for a spherical shell is (where, K = thermal conductivity of insulating material h₀ = heat transfer coefficient at the outer surface)

View solution

Q. Radiator of an automobile engine is a __________ type of heat exchanger.

View solution

Q. In pipe flow, heat is transferred from hot wall to the liquid by

View solution

Q. Which of the following has the minimum absorptivity ?

View solution

Q. A black body when hot, emits heat radiation of __________ wavelengths.

View solution

Q. A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when

View solution

Q. Vibrations in the tubes of a shell and tube heat exchanger is induced due to the

View solution

Q. Heat transfer by conduction in the turbulent core of a fluid flowing through a heated pipe is negligible, if the value of Prandtl number is

View solution

Q. For __________ Prandtl number values, the heat conduction will be negligible in the buffer zone.

View solution

Q. The radiation heat flux from a heating element at a temperature of 800°C, in a furnace maintained at 300°C is 8 kW/m². The flux, when the element temperature is increased to 1000°C for the same furnace temperature is

View solution

Q. Heat exchangers operating, when the asymptotic range is reached,

View solution

Q. In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell)

View solution

Q. In case of heat transfer by conduction in a hollow cylinder, __________ mean area is used to calculate the heat transfer rate.

View solution

Q. Multiple effect evaporators are used to

View solution

Q. Small scale evaporation is done in a

View solution

Q. Heat exchanger tubes are never made of

View solution

Q. At constant temperature, the thermal conductivities of gases __________ with rise in pressure.

View solution