Q. Multiple effect evaporators are used to

View solution

Q. Small scale evaporation is done in a

View solution

Q. Heat exchanger tubes are never made of

View solution

Q. At constant temperature, the thermal conductivities of gases __________ with rise in pressure.

View solution

Q. A __________ evaporator employs an annular downtake.

View solution

Q. Radiation heat losses from satisfactorily insulated high pressure boilar may be about __________ percent.

View solution

Q. In natural convection heat transfer, the correlating parameter is the

View solution

Q. Boiling of milk in an open vessel is an example of __________ boiling.

View solution

Q. Pick out the wrong statement.

View solution

Q. The value of Stefan-Boltazman constant in SI unit is

View solution

Q. The unit of heat transfer co-efficient is

View solution

Q. For turbulent flow in a tube, the heat transfer co-efficient is obtained from the Dittus-Boelter correlation. If the tube diameter is halved and the flow rate is doubled, then the heat transfer co-efficient will change by a factor of

View solution

Q. The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m⁻¹.°C⁻¹ respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m⁻².°C⁻¹. The rate of heat loss from the outer surface in W.m⁻² is

View solution

Q. Value of Nusselt number [Nu = (hD/k)] for the heat transfer by conduction from a droplet or a spherical particle to a surrounding stagnant film is

View solution

Q. Pick out the wrong statement.

View solution

Q. Evaporation by thermocompression results in the

View solution

Q. Forced circulation evaporators are normally used for concentrating liquids having

View solution

Q. Steam economy in case of a triple effect evaporator will be

View solution

Q. In a heat exchanger with steam outside the tubes, a liquid gets heated to 45°C, when its flow velocity in the tubes is 2 m/s. If the flow velocity is reduced to 1 m/s, other things remaining the same, the temperature of the exit liquid will be

View solution

Q. Multiple effect evaporation accounts for

View solution