Q. Boiling of milk in an open vessel is an example of __________ boiling.

View solution

Q. Pick out the wrong statement.

View solution

Q. The value of Stefan-Boltazman constant in SI unit is

View solution

Q. The unit of heat transfer co-efficient is

View solution

Q. For turbulent flow in a tube, the heat transfer co-efficient is obtained from the Dittus-Boelter correlation. If the tube diameter is halved and the flow rate is doubled, then the heat transfer co-efficient will change by a factor of

View solution

Q. The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m⁻¹.°C⁻¹ respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m⁻².°C⁻¹. The rate of heat loss from the outer surface in W.m⁻² is

View solution

Q. Value of Nusselt number [Nu = (hD/k)] for the heat transfer by conduction from a droplet or a spherical particle to a surrounding stagnant film is

View solution

Q. Pick out the wrong statement.

View solution

Q. Evaporation by thermocompression results in the

View solution

Q. Forced circulation evaporators are normally used for concentrating liquids having

View solution

Q. Steam economy in case of a triple effect evaporator will be

View solution

Q. In a heat exchanger with steam outside the tubes, a liquid gets heated to 45°C, when its flow velocity in the tubes is 2 m/s. If the flow velocity is reduced to 1 m/s, other things remaining the same, the temperature of the exit liquid will be

View solution

Q. Multiple effect evaporation accounts for

View solution

Q. In case of a supercooled solution, which is on the verge of crystallisation, the free energy of the solution as compared to that of the solid is

View solution

Q. Maximum water velocity in tubes of a 1-2 shell and tube heat exchanger may be around __________ metres/second.

View solution

Q. In Biot number, the characteristic length used is the ratio of the __________ of the solid.

View solution

Q. Which of the following is the most widely used heat insulating material for pipelines carrying steam ?

View solution

Q. Heat transfer co-efficient equation for forced convection, Nu = 0.023 Re^0.8 . Prⁿ, is not valid, if the value of

View solution

Q. Which is the best tube arrangement (in a shell and tube heat exchanger) if the fluids are clean and non-fouling ?

View solution

Q. In case of a multipass shell and tube heat exchanger, the temperature drop in the fluid

View solution