Q. Steam distillation is used to separate

View solution

Q. In distillation where q is defined as the moles of liquid flow in the stripping section per mole of feed introduced, for saturated liquid feed

View solution

Q. The cooling effect in a cooling tower can not be increased by

View solution

Q. The value of Nᴀ/(Nᴀ + Nʙ) for steady state molecular diffusion of gas 'A' through non-diffusing gas 'B' is

View solution

Q. The humid volume may be increased by increasing the

View solution

Q. Pick out the wrong statement

View solution

Q. When the mixture to be distilled has a very high boiling point and the product material is heat sensitive, the separation technique to be used is __________ distillation.

View solution

Q. Leaching of uranium ore and gold ore is done in

View solution

Q. Blowdown in a cooling tower

View solution

Q. During constant rate period, the rate of drying decreases with the

View solution

Q. Antibiotics are best handled in a

View solution

Q. The fixed cost of a distillation column at minimum reflux ratio is

View solution

Q. To get high tray efficiency

View solution

Q. The mass transfer co-efficient for a solid sphere of radius 'a' dissolving in a large volume of quiescent liquid, in which D is the diffusivity of solute, is

View solution

Q. Pick out the wrong statement. Generally for physical adsorption, a gas of

View solution

Q. In most of the mechanically agitated liquid-liquid extractors, baffles or horizontal compartmental plates are provided, which helps in

View solution

Q. Which of the following is an undesirable property in a tower packing ?

View solution

Q. Water entrained by circulating air in cooling towers is termed as

View solution

Q. A 25 cm x 25 cm x 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m x 1m x 1cm flat sheet of the same material is to be dried from one side only.Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is

View solution

Q. With increase in temperature, the rate of leaching increases, because the

View solution