Question
a.
higher molecular weight is adsorbed in preference to a gas of low molecular weight.
b.
high critical temperature is adsorbed in preference to a gas of low critical temperature.
c.
low volatility is adsorbed in preference to a gas of high volatility.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick out the wrong statement. Generally for physical adsorption, a gas of
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In most of the mechanically agitated liquid-liquid extractors, baffles or horizontal compartmental plates are provided, which helps in
View solution
Q. Which of the following is an undesirable property in a tower packing ?
View solution
Q. Water entrained by circulating air in cooling towers is termed as
View solution
Q. A 25 cm x 25 cm x 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m x 1m x 1cm flat sheet of the same material is to be dried from one side only.Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is
View solution
Q. With increase in temperature, the rate of leaching increases, because the
View solution
Q. Humidity chart is useful for the solution of problems concerning condensation, vaporisation and air conditioning. At a given dry bulb temperature, value of humidity obtained from the humidity chart directly, is in terms of __________ humidity.
View solution
Q. The apex of an equilateral-triangular coordinate (in ternary liquid system) represents a/an
View solution
Q. A slurry is to be dried to produce flaky solid. Which dryer would you recommend ?
View solution
Q. Which of the following psychrometric processes is followed by water vapour laden unsaturated air, when it is passed through solid or liquid adsorbent ?
View solution
Q. Boiling point diagram is
View solution
Q. When acetone is added in a two layer mixture of methyl isobutyl ketone and water at 30°C, the acetone distributes between the two layers and the composition of the layer follows two solubility curves. For this system,
View solution
Q. Steam distillation is used to
View solution
Q. Freundlich equation applies to the adsorption of solute from
View solution
Q. For ethanol-water system, the lowering of distillate quality from 95% to 92% will cause __________ plate requirement.
View solution
Q. A packed tower compared to a plate tower for a particular mass transfer operation
View solution
Q. Which of the following is the most commonly used leaching solvent in vegetable oil industry ?
View solution
Q. In an absorber, HETP does not vary with the
View solution
Q. Large quantity of silica gel is normally dried in a __________ dryer.
View solution
Q. For the same system, if the same liquid used in an absorber is decreased, the tower height will
View solution
Q. Which of the following same diameter columns gives lowest pressure drop per unit height ?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!