Question
a.
Murphree efficiency > point efficiency.
b.
Murphree efficiency < point efficiency.
c.
Murphree efficiency = point efficiency.
d.
Murphree efficiency ≠ point efficiency.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When the liquid over a plate is of uniform concentration, then
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In saturated gas, the
View solution
Q. Moisture in a solid exerting an equilibrium vapour pressure equal to that of the pure liquid at the same temperature is called the __________ moisture.
View solution
Q. Inside the distillation columns, the
View solution
Q. When the psychometric ratio is __________ then the adiabatic saturation temperature and wet bulb temperature becomes equal.
View solution
Q. Desirable value of absorption factor in an absorber is
View solution
Q. Refractory bricks are usually dried in a __________ dryer.
View solution
Q. When the gas to be dissolved in liquid is a/an __________ then normally co-current adsorber are used.
View solution
Q. Corresponding to Prandtl number in heat transfer, the dimensionless group in mass transfer is the __________ number.
View solution
Q. If a two phase system is in physical equilibrium; then it means that, the
View solution
Q. McCabe-Thiele method of binary distillation does not assume that the
View solution
Q. (NSh/NRe.NSc) is termed in mass transfer operation as the
View solution
Q. In a binary system, separation is very efficient, when the relative volatility is
View solution
Q. Fenske-Underwood equation used for calculating the minimum number of theoretical plates in distillation column is valid for
View solution
Q. The binary diffusivity in gases does not depend upon the
View solution
Q. Berl saddle made of carbon cannot be used for
View solution
Q. 1 kg of a saturated aqueous solution of a highly soluble component A at 60°C is cooled to 25°C. The solubility limits of A are (0.6 kgA/kg water) at 60°C and (0.2 kgA/kg water) at 25°C. The amount in kg of the crystals formed is
View solution
Q. Pick out the wrong statement. Raoult's law does not apply, when the
View solution
Q. Water-ethyl alcohal solution can be concentrated (in respect of alcohal concentration) by __________ distillation.
View solution
Q. L/mG is the expression for
View solution
Q. Extraction of pencillin employs a __________ extraction coloumn.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
