Q. For a single component absorber, the operating line is straight only when plotted in term of __________ units.

View solution

Q. Raschig ring made of procelain cannot be used for treating concentrated

View solution

Q. H₂S present in naphtha reformed gas is removed by absorbing with

View solution

Q. During constant rate drying period, vaporisation rate per unit drying surface area

View solution

Q. Pick out the wrong statement.

View solution

Q. In rectifying section of a continuous distillation column, the

View solution

Q. For a distillation column operating at minimum reflux, the

View solution

Q. A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))

View solution

Q. Flash distillation is suitable for the separation of components

View solution

Q. In Mcabe-Thiele method, at infinite reflux ratio

View solution

Q. Leaching rate is independent of the

View solution

Q. Molality is defined as the number of gm moles of solute per __________ of solvent.

View solution

Q. __________ is concerned with the adsorption equilibria.

View solution

Q. Fractional solvent extraction

View solution

Q. In the layout plan for a vacuum distillation unit, operating at 60 mm Hg, supported by a barometric condenser, the appropriate place for the location of vacuum drum for collecting the distillate will be

View solution

Q. At 750°K and 1 atm, the approximate value of Schmidt number for air is

View solution

Q. Calculation of mass transfer co-efficient is mostly/normally done using __________ theory.

View solution

Q. Which of the following is used for the concentration of rubber latex ?

View solution

Q. Unsaturated air (with dry and wet bulb temperatures being 35 and 25°C respectively) is passed through water spray chamber maintained at 35°C. The air will be

View solution

Q. For absorbing a sparingly soluble gas in a liquid, the

View solution