Question

A bypass stream in a chemical process is useful, because it

a.

facilitates better control of the process.

b.

improves the conversion.

c.

increases the yield of products.

d.

none of these.

Answer: (a).facilitates better control of the process.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A bypass stream in a chemical process is useful, because it

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. 1 ata is equivalent to

Q. 1 BTU/ft³ is approximately equal to __________ kcal/m³.

Q. At 100°C, water and methylcyclohexane both have vapour pressures of 1 atm. Also at 100°C, the latent heats of vaporisation of these compounds are 40.63 kJ/mole for water and 31.55 kJ/mole for methylcyclohexane. The vapour pressure of water at 150°C is 4.69 atm. At 150°C, the vapour pressure of methylcyclohexane would be expected to be

Q. Pick out the wrong statement.

Q. Which of the following ratios defines the recycle ratio in a chemical process ?

Q. NaOH contains __________ percent oxygen.

Q. Addition of a non-volatile solute to a solvent produces a __________ in its solvent.

Q. The pH value of a solution is 5.9. If the hydrogen ion concentration is decreased hundred times, the solution will be

Q. Hess's law of constant heat summation is based on conservation of mass. It deals with

Q. Percentage saturation of a vapor bearing gas is always __________ the relative saturation.

Q. Cᵨ is expressed in S.I. unit as

Q. What is the total pressure exerted by a mixture of 0.45 kg mole of benzene, 0.44 kg mole of toluene and 0.23 kg mole of o-xylene at 100°C, if their vapor pressures at 100°C are 1340, 560 and 210 mmHg respectively ?

Q. 1 kg/cm² is equal to

Q. An azeotropic solution of two liquids has boiling point lower than either of them, when it

Q. For a given mass of a gas at constant temperature, if the volume 'V' becomes three times, then the pressure 'P' will become

Q. One kg of saturated steam at 100°C and 1.01325 bar is contained in a rigid walled vessel. It lias a volume of 1.673 m³. It cools to 98°C ; the saturation pressure is 0.943 bar ; one kg of water vapour under these conditions has a volume of 1.789 m³. The latent heat of condensation (kJ/kg⁻¹ ) under these conditions is

Q. Weight of 56 litres of ammonia at N.T.P. is __________ gm.

Q. Concentration of a solution expressed in terms of __________ is independent of temperature.

Q. The average translational kinetic energy with which a gas molecule is endowed is dependent on its

Q. The vapor pressure of a substance, at its melting point, is __________ in the solid state as compared to that in the liquid state.

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!