Q. In perforated plate towers, the

View solution

Q. The main purpose of providing stepping on the trays is to

View solution

Q. The operating pressure drop range in a bag filter is about __________ mm water gauge.

View solution

Q. In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.

View solution

Q. The stress developed in a material without any permanent set is called the

View solution

Q. In a shell and tube heat exchanger, the 'tube pitch' is defined as the

View solution

Q. Which of the following is not a valid assumption in continuous binary distillation for calculating the number of equilibrium stages by Mc-Cabe-Thiele's method ?

View solution

Q. Pick out the wrong statement pertaining to the design of the bubble cap tray of a distillation column to give stable operation and even vapour distribution.

View solution

Q. Speed of the drum of the rotary vacuum filter normally ranges from __________ rpm.

View solution

Q. A stuffing box is used for

View solution

Q. Pressure drop (Δp) and the superficial gas mass velocity (G) in case of packed absorption tower operating in the preloading range are related as

View solution

Q. Pick out the wrong statement.

In an agitated vertical cylinderical reaction vessel, the

View solution

Q. The value of fouling factor depends upon the

View solution

Q. In case of bubble cap distillation column of diameter greater than 1.2 metres, the cap diameter is roughly about __________ cms.

View solution

Q. Tube side pressure drop in a 1-2 heat exchanger (for turbulent flow of fluids through the tubes) is about __________ times, that in a 1-1 heat exchanger having the same size & number of tubes and operated at the same liquid flow rate.

View solution

Q. To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of

View solution

Q. In a heat exchanger, shell side fluid velocity can be changed by changing the tube

View solution

Q. Where does the maximum tensile strength occur in a thick cylindrical vessel subjected to internal pressure ?

View solution

Q. It is not desirable to design a heat exchanger for LMTD correction factor, Fᴛ, of less than

View solution

Q. A rivetted joint does not fail by __________ of rivets.

View solution