Q. The retention time of material in a rotary dryer depends upon its

View solution

Q. In actual operation of a bubble cap distillation tower, the __________ at the bottom of the tower is more than that at the top of the tower.

View solution

Q. Rotary driers are most economically designed for the number of heat transfer units (HTU) from

View solution

Q. The difficulty of liquid distribution in packed towers is accentuated, when the ratio of tower diameter to packing diameter is

View solution

Q. A forced circulation long tube vertical evaporator as compared to the natural circulation evaporator

View solution

Q. For storing hazardous chemicals in large storage tanks, the minimum safe distance between the two tanks should range between __________ times the tank diameter.

View solution

Q. Which of the following factors determine the amount of entrainment in a distillation column ?

View solution

Q. The absorption factor is defined as (where, S₁ = slope of the equilibrium curve, S₂ = slope of the operating line)

View solution

Q. In shell and tube heat exchangers, straight tie rods are used to

View solution

Q. A binary liquid azeotropic mixture has boiling point higher than either of the components, when it shows __________ deviation from Raoult's Law.

View solution

Q. The testing pressure of storage tanks and pressure vessels designed as per Indian standard codes should be about __________ times the design pressure.

View solution

Q. Flanges are connected to pipes by

View solution

Q. The ratio of down take area to cross-sectional area of the tube, for calendria type evaporator ranges from

View solution

Q. Shortest distance between two tubes is

View solution

Q. An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by

View solution

Q. In the design of a bag filter, the gas temperature is an important consideration, as it affects the

View solution

Q. With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, Fт

View solution

Q. The normal range of velocity of steam in pipes is __________ m/sec.

View solution

Q. __________ dished head is the strongest of all.

View solution

Q. Hazards associated with the relief valve leakage for extremely hazardous material storage can be taken care of by providing

View solution