Q. With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, Fт

View solution

Q. The normal range of velocity of steam in pipes is __________ m/sec.

View solution

Q. __________ dished head is the strongest of all.

View solution

Q. Hazards associated with the relief valve leakage for extremely hazardous material storage can be taken care of by providing

View solution

Q. Minimum baffle spacing recommended in a shell and tube heat exchanger is equal to

View solution

Q. __________ liquor is best handled in a long tube vertical evaporator.

View solution

Q. Theoretically calculated diameter of the stripping section of the continuous rectification column is __________ that of the enriching section.

View solution

Q. Hold up of material in a operating rotary drier is in the range of

View solution

Q. In case of design of a shell and tube heat exchanger,

View solution

Q. In a cylinderical vessel subjected to internal pressure, the longitudinal stress σʟ and the circumferential stress, σₙ are related by

View solution

Q. Nominal size of a pipe is an indication of its __________ diameter.

View solution

Q. Excessive liquid gradient on a tray may result in the

View solution

Q. The ratio of tube length to shell diameter in case of liquid shell and tube heat exchanger ranges from

View solution

Q. What is the slope of the operating line in the stripping section of a distillation column ?

View solution

Q. __________ shaped roof is most commonly used for cylindrical tanks.

View solution

Q. In a thin cylindrical shell, the hoop stress is __________ stress.

View solution

Q. Commercial packed scrubbers are normally designed for a pressure drop range of __________ mm water coloumn per metre of packed height.

View solution

Q. Pick out the correct statement.

View solution

Q. "A claming section" before the liquid flows into the downcomer is privided to

View solution

Q. The units of Young's modulus of elasticity and __________ are the same.

View solution