Question
a.
2 to 3
b.
3 to 5
c.
4 to 8
d.
6 to 12
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The ratio of tube length to shell diameter in case of liquid shell and tube heat exchanger ranges from
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. What is the slope of the operating line in the stripping section of a distillation column ?
View solution
Q. __________ shaped roof is most commonly used for cylindrical tanks.
View solution
Q. In a thin cylindrical shell, the hoop stress is __________ stress.
View solution
Q. Commercial packed scrubbers are normally designed for a pressure drop range of __________ mm water coloumn per metre of packed height.
View solution
Q. Pick out the correct statement.
View solution
Q. "A claming section" before the liquid flows into the downcomer is privided to
View solution
Q. The units of Young's modulus of elasticity and __________ are the same.
View solution
Q. In the design of a shell and tube heat exchanger, the corrosion allowance
View solution
Q. Vertical condenser is advantageous to the horizontal condenser from operation point of view, when
View solution
Q. In common bubble cap distillation column design practice, riser area is approximately equal to (where, Aₐ = Annular passage area, and Sₐ = Slot area)
View solution
Q. Heat transfer co-efficient, hԍ(Kcal/hr.m² .°C) and mass velocity of air, G (kg/hr.m² ) for air flow parallel to the surface in case of constant drying rate in batch drying is related as hԍ = 0.0176G^0.8. But when the flow of air perpendicular to the surface is encountered, this equation changes to
View solution
Q. In the agitators, the power required will be changed with the increase of diameter of agitator (D) as
View solution
Q. Apex angle of conical heads used in the bottom heads of chemical process equipments is usually
View solution
Q. A 'rupture disc' is provided in chemical equipments as an accessory meant for
View solution
Q. In a vertical short tube evaporator (Calendria type), the
View solution
Q. In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a
View solution
Q. In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is
View solution
Q. Any shell opening greater than 5 cms for a storage tank must be reinforced for reason of
View solution
Q. The thermal stress in a metallic bar does not depend upon the
View solution
Q. The minimum baffle height should be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!