Question

Hold up of material in a operating rotary drier is in the range of

a.

0.05 to 0.15

b.

0.25 to 0.50

c.

0.5 to 0.8

d.

0.8 to 0.9

Answer: (a).0.05 to 0.15

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Hold up of material in a operating rotary drier is in the range of

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In case of design of a shell and tube heat exchanger,

Q. In a cylinderical vessel subjected to internal pressure, the longitudinal stress σʟ and the circumferential stress, σₙ are related by

Q. Nominal size of a pipe is an indication of its __________ diameter.

Q. Excessive liquid gradient on a tray may result in the

Q. The ratio of tube length to shell diameter in case of liquid shell and tube heat exchanger ranges from

Q. What is the slope of the operating line in the stripping section of a distillation column ?

Q. __________ shaped roof is most commonly used for cylindrical tanks.

Q. In a thin cylindrical shell, the hoop stress is __________ stress.

Q. Commercial packed scrubbers are normally designed for a pressure drop range of __________ mm water coloumn per metre of packed height.

Q. Pick out the correct statement.

Q. "A claming section" before the liquid flows into the downcomer is privided to

Q. The units of Young's modulus of elasticity and __________ are the same.

Q. In the design of a shell and tube heat exchanger, the corrosion allowance

Q. Vertical condenser is advantageous to the horizontal condenser from operation point of view, when

Q. In common bubble cap distillation column design practice, riser area is approximately equal to (where, Aₐ = Annular passage area, and Sₐ = Slot area)

Q. Heat transfer co-efficient, hԍ(Kcal/hr.m² .°C) and mass velocity of air, G (kg/hr.m² ) for air flow parallel to the surface in case of constant drying rate in batch drying is related as hԍ = 0.0176G^0.8. But when the flow of air perpendicular to the surface is encountered, this equation changes to

Q. In the agitators, the power required will be changed with the increase of diameter of agitator (D) as

Q. Apex angle of conical heads used in the bottom heads of chemical process equipments is usually

Q. A 'rupture disc' is provided in chemical equipments as an accessory meant for

Q. In a vertical short tube evaporator (Calendria type), the

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!