Q. __________ tower is the most suitable gas-liquid contacting device involving highly corrosive fluids.

View solution

Q. At equal mass velocities, the values of film co-efficients for gases as compared to that for liquids are generally.

View solution

Q. The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the __________ stress.

View solution

Q. Baffle spacing is generally __________ the I.D. of the shell.

View solution

Q. The wall thickness of thin cylindrical shell with hemispherical ends is __________ that of the spherical ends.

View solution

Q. The average velocity in the tubes of a 1-4 heat exchanger is __________ times that in 1-1 heat exchanger having the same size & number of tubes and operated at same liquid flow rate.

View solution

Q. Hoop (circumferential) stress induced in a thin walled 'Horton Sphere' used for the storage of liquid ammonia under pressure is

View solution

Q. When one of the fluids is highly corrosive and has fouling tendency, it should

View solution

Q. A/an __________ is used for changing the direction of a pipeline.

View solution

Q. Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.

View solution

Q. Liquid redistribution should be done in a packed tower packed with raschig rings every 6 metres or __________ times the column diameter, whichever is lower.

View solution

Q. Slope of countercurrent flow rotary drier is in the range of __________ meter/metre.

View solution

Q. In case of saddle packing (e.g., berl and intralox saddles), the maximum size of the packing should not exceed __________ of the column diameter.

View solution

Q. Seamless pipe is made

View solution

Q. Pick out the wrong statement pertaining to the design of the distillation column.

View solution

Q. The longitudinal stress induced in a thin walled cylinderical vessel under internal pressure is

View solution

Q. In distillation columns, bubble caps are held in place over trays by

View solution

Q. The buckling tendency of compression members is always in the direction of the

View solution

Q. In case of plain carbon steel, butt welded joints are used for shell plate thickness ≤ __________ cms.

View solution

Q. Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle ?

View solution