Question
a.
shape.
b.
outside diameter.
c.
height.
d.
all (a), (b) & (c).
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The force due to wind load acting on a tall vessel depends upon its
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Bubble cap diameter used for the distillation column having diameter ranging from 1.5 to 4.5 metres is about __________ mm.
View solution
Q. Power required for agitation depends upon the
View solution
Q. Tube height in a calendria type evaporator is normally less than __________ metres.
View solution
Q. Pick out the wrong statement.
View solution
Q. For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.
View solution
Q. Cylinderical shell thickness of rotary drier is generally __________ mm.
View solution
Q. The ratio of lateral strain to linear strain is termed as the
View solution
Q. The distance between the centre of a rivet hole to the nearest edge of the plate is called
View solution
Q. Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the
View solution
Q. A minimum clearance of about __________ mm is maintained between the distillation column wall and the bubble cap.
View solution
Q. Lₑ/D for 90° elbow (medium radius) and 90°square elbow would be respectively around
View solution
Q. __________ heat exchanger is also known as 'hair pin type' exchanger,
View solution
Q. What is the value of 'q' for saturated vapor feed to a distillation column ?(where q = fraction of the feed stream that is liquid.)
View solution
Q. In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around
View solution
Q. Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
View solution
Q. Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation
View solution
Q. Lₑ/D for a Tee (used as elbow, entering run) would be around
View solution
Q. Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
View solution
Q. Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
View solution
Q. Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8").
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!