Q. __________ heat exchanger is also known as 'hair pin type' exchanger,

View solution

Q. What is the value of 'q' for saturated vapor feed to a distillation column ?(where q = fraction of the feed stream that is liquid.)

View solution

Q. In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around

View solution

Q. Frame thickness in the plate and frame filter press is normally in the range of __________ inches.

View solution

Q. Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation

View solution

Q. Lₑ/D for a Tee (used as elbow, entering run) would be around

View solution

Q. Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always

View solution

Q. Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.

View solution

Q. Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8").

View solution

Q. Pick out the wrong statement.

View solution

Q. Pick out the wrong statement pertaining to shell and tube heat exchanger.

View solution

Q. Wind load consideration in the design of a support can be neglected, when the vessel is

View solution

Q. The ratio of volumes of the mixed reactor to the plug flow reactor (for identical feed composition, flow rate, conversion, and for all positive reaction orders) is always

View solution

Q. A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is

View solution

Q. Scale up problem in design based on the similarity concept takes into account __________ similarity.

View solution

Q. __________ closure is the weakest enclosure for cylindrical vessels.

View solution

Q. Which of the following efficiencies can be greater than 100% ?

View solution

Q. Optimum economic pipe diameter for fluid flow is determined by the

View solution

Q. Pressure differential maintained across a continuous rotary vacuum filter is in the range of __________ mm Hg column.

View solution

Q. Vertical storage vessels are never supported by __________ support.

View solution