Q. A free jet of water of cross-sectional area 0.01 m² and a velocity of 20 m/s strikes a plate and then flows in a plane parallel to the plate as shown in the figure below. The horizontal component of the force on the support is

View solution

Q. Pressure drop for laminar fluid flow through a circular pipe is given by

View solution

Q. Drag co-efficient for motion of spherical particles in a stationary fluid in the stoke's law range is

View solution

Q. Hydraulic mean radius for flow through packed bed of spherical particle of size, 'Dₚ', with porosity 'ε' is

View solution

Q. A conical tank with a bottom opening of cross-sectional area A is filled with water and is mounted on supports as shown in the figure. What is the force F with which plate X must be pushed up to prevent water from leaking ? Assume that the density of air is negligible as compared to the density of water ρL.

View solution

Q. The equivalent diameter for pressure drop calculation for a duct of square cross-section is given by(where, x = each side of the square duct)

View solution

Q. Each term of the Bernoulli's equation written in the following form, represents the total energy per unit

View solution

Q. For one dimensional flow of an incompressible fluid in unsteady state in x-direction, the continuity equation is given by

View solution

Q. The inherent characteristic of an equal percentage valve relating flow rate 'q' with valve stem movement 'x' are described by the equation

View solution

Q. Curve III in the below diagram represents a/an

View solution

Q. Colebrook equation for friction factor in turbulent flow is given by following equation. It reduces to Nikuradse equation for a value of ε/D equal to

View solution

Q. The percentage slip in a reciprocating pump set is given by the % of (where, Q₁ = actual discharge Q₂ = theoretical discharge)

View solution

Q. A particle A of diameter 10 microns settles in an oil of specific gravity 0.9 and viscosity 10 poise under Stoke's law. A particle B with diameter 20 microns settling in the same oil will have a settling velocity

View solution

Q. The pitot static tube does not measure the __________ pressure.

View solution

Q. The fluid in which the shearing stress within it is proportional to the velocity gradient across the sheared section, is called a __________ fluid.

View solution

Q. In fluid flow, cavitation is caused, if the

View solution

Q. The ratio of the depth of flow to the hydraulic radius for the most economical trapezoidal section, in open channel flow is

View solution

Q. Which of the following denotes the effect of compressibility in fluid flow ?

View solution

Q. Nominal size of the discharge pipe of a pump is usually __________ the nominal size of the inlet pipe.

View solution

Q. The terminal velocity of a small sphere settling in a viscous fluid varies as the

View solution