Question

Curve III in the below diagram represents a/an

a.

dilatent fluid

b.

pseudo plastic fluid

c.

ideal plastic

d.

none of these

Answer: (b).pseudo plastic fluid

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Curve III in the below diagram represents a/an

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Colebrook equation for friction factor in turbulent flow is given by following equation. It reduces to Nikuradse equation for a value of ε/D equal to

Q. The percentage slip in a reciprocating pump set is given by the % of (where, Q₁ = actual discharge Q₂ = theoretical discharge)

Q. A particle A of diameter 10 microns settles in an oil of specific gravity 0.9 and viscosity 10 poise under Stoke's law. A particle B with diameter 20 microns settling in the same oil will have a settling velocity

Q. The pitot static tube does not measure the __________ pressure.

Q. The fluid in which the shearing stress within it is proportional to the velocity gradient across the sheared section, is called a __________ fluid.

Q. In fluid flow, cavitation is caused, if the

Q. The ratio of the depth of flow to the hydraulic radius for the most economical trapezoidal section, in open channel flow is

Q. Which of the following denotes the effect of compressibility in fluid flow ?

Q. Nominal size of the discharge pipe of a pump is usually __________ the nominal size of the inlet pipe.

Q. The terminal velocity of a small sphere settling in a viscous fluid varies as the

Q. If the discharge of a centrifugal pump is throttled, then its suction lift

Q. Foot valves provided in pumps are __________ valves.

Q. With increasing flow rate, the hydraulic efficiency of a centrifugal pump

Q. The velocity profile for turbulent flow through a closed conduit is

Q. In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of

Q. Water hammer in a pipeline results from the

Q. Molten soap mass is transported by a __________ pump.

Q. At high Reynolds number

Q. Power loss in an orificemeter is __________ that in a venturimeter.

Q. The terminal velocity of a particle moving through a fluid varies as dₚⁿ. What is the value of 'n' for Newton's law regime ?

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!