Q. With increasing flow rate, the hydraulic efficiency of a centrifugal pump

View solution

Q. The velocity profile for turbulent flow through a closed conduit is

View solution

Q. In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of

View solution

Q. Water hammer in a pipeline results from the

View solution

Q. Molten soap mass is transported by a __________ pump.

View solution

Q. At high Reynolds number

View solution

Q. Power loss in an orificemeter is __________ that in a venturimeter.

View solution

Q. The terminal velocity of a particle moving through a fluid varies as dₚⁿ. What is the value of 'n' for Newton's law regime ?

View solution

Q. What is the normal range of exit cone angle of a venturimeter ?

View solution

Q. The dimension of dynamic viscosity is

View solution

Q. Co-efficient of velocity is __________ the coefficient of discharge.

View solution

Q. All pipes of a particular nominal size have the same

View solution

Q. For the transfer of solution of thick slurry, the pump used is a __________ pump.

View solution

Q. Which of the following is not concerned with the fluid-particle interaction ?

View solution

Q. Maximum theoretical suction lift for water at 15°C by a centrifugal pump is 34 ft. The same for water at 90°C will be __________ ft.

View solution

Q. Pick out the wrong statement.

View solution

Q. Pressure drag does not depend upon the

View solution

Q. Dimension of absolute viscosity is

View solution

Q. __________ pumps are axial flow pumps.

View solution

Q. Brownian movement is prominent in the particle size range of __________ microns in case of settling of a particle in a fluid.

View solution