Q. The transfer function for an ideal proportional plus reset controller (reset time T) is

View solution

Q. The transfer function for a P-D controller is

View solution

Q. What is the overall transfer function (C/R) of the following block diagram if G = G₁. G₂. G₃ and H = H₁.H₂.

View solution

Q. Transfer functions X/Y for which of the following block diagrams is

View solution

Q. The transfer function for a first order process with time delay is

View solution

Q. An ideal PID controller has the transfer function [1 + 1/0.55 + 0.25 ]. The frequency at which the magnitude ratio of the controller is 1, is

View solution

Q. The unit step response of the following transfer function reaches its final steady state assymptotically after

View solution

Q. A process is initially at steady state with its output y=1 for an input u=1. The input is suddenly changed to 2 at time t=0. The output response is y(t)=1+2t. The transfer function of the process is

View solution

Q. Which of the systems having the following transfer function is stable ?

View solution

Q. The calibration data of a thermocouple with its cold junction at 0°C are given below.
The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple ?

View solution

Q. The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function

View solution

Q. For the block diagram shown below, the characteristic equation is

View solution

Q. The experimental response of the controlled variable y(t) for a step change of magnitude P in the manipulated variable x(t) is shown below.
The appropriate transfer function of the process is

View solution

Q. The open loop transfer function of a process is given below. In the root locus diagram, the poles will be at

View solution

Q. Water is entering a storage tank at a temperature T₀ and flow rate Q₀ and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A₀. The model that describes the dynamic variation of temperature of water in the tank with time is given as :

View solution

Q. The transfer function of a second order system is

View solution

Q. The Laplace transform of a sinusoidal function (eg; sin at) is represented by the curve

View solution

Q. The transfer function of a first order system is

View solution

Q. The transfer function of a pure dead time system with dead time τd is

View solution

Q. Which of following error integral is considered as the best criterion in controller settings ?

View solution