Question
a.
in the zone of complete turbulence.
b.
when the roughness projections are much smaller than the thickness of the laminar film.
c.
everywhere in the transition zone.
d.
when the friction factor is independent of the Reynold's number.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In turbulent flow, a rough pipe has the same friction factor as a smooth pipe
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Air vessel provided in a reciprocating pump
View solution
Q. Bernoulli's equation is dependent on the
View solution
Q. A fluid element has a velocity V = -y² . xi + 2yx² . j. The motion at (x, y) = (l/√2, 1) is
View solution
Q. Check in a centrifugal pump is
View solution
Q. Drag force acting on a body does not depend upon the
View solution
Q. Centrifugal pump is normally classified on the basis of the
View solution
Q. Where does the maximum stress occur in case of laminar flow of incompressible fluid in a closed conduit of diameter 'd'?
View solution
Q. A mono pump is a __________ pump.
View solution
Q. Higher specific speed (200-500) of a centrifugal pump indicates that the pump is of __________ flow type.
View solution
Q. The variable required to be known in correlations used for estimating the horse power of a centrifugal gas compressor and hence its cost are
P. Inlet pressure
Q. Compressor rpm
R. Delivery pressure
S. Volumetric flow rate at inlet.
View solution
Q. Theoretical head developed by a centrifugal pump does not depend upon the __________ the impeller.
View solution
Q. An ideal fluid is
View solution
Q. In case of isentropic flow, the speed of sound in an ideal gas is proportional to (where, T = absolute temperature )
View solution
Q. Applying a pressure drop across a capillary results in a volumetric flow rate 'Q' under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is
View solution
Q. Cd, C and Cv are related (for flow through an orifice) as
(where, Cd = discharge co-efficient
Cc = co-efficient of contraction = area of jet at vena-contracta / area of opening
Cv = co-efficient of velocity = actual velocity at vena-contracta / Theoretical velocity )
View solution
Q. In an incompressible fluid, the density is
View solution
Q. Check valves are used
View solution
Q. Velocity distribution for flow between two fixed parallel plates
View solution
Q. Priming is needed in a __________ pump.
View solution
Q. An ideal nozzle design aims at
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
