Q. For a given fluid flow rate, which of the following incurs maximum head loss ?

View solution

Q. Which of the following assumptions enables the Euler's equation of motion to be integrated ?

View solution

Q. In case of a pipe exit fitted with a nozzle, the

View solution

Q. A fluid whose apparent viscosity increases with shear rate is termed as the __________ fluid.

View solution

Q. Pascal law is not applicable for a/an __________ fluid.

View solution

Q. In a fluidised bed reactor

View solution

Q. The flow of a liquid through tapering pipe at a constant rate is an example of __________ flow.

View solution

Q. Pick out the correct statement pertaining to transition/ entrance length in fluid flow.

View solution

Q. A perfect gas

View solution

Q. Which of the following is the most common pump for pumping either raw sewage or sludge ?

View solution

Q. Transition length for a turbulent fluid entering into a pipe is around __________ times the pipe diameter.

View solution

Q. For turbulent flow of an incompressible fluid through a pipe, the flow rate Q is proportional to (Δ P)n, where ΔP is the pressure drop. The value of exponent 'n' is

View solution

Q. Reciprocating pumps are not able to compete with the centrifugal pump for industrial use, mainly because these pumps have

View solution

Q. The ratio of hydrodynamic boundary layer to thermal boundary layer thickness in case of liquid metals is

View solution

Q. The general relationship between speed N, head H, power P and discharge Q for a centrifugal pump is

View solution

Q. What is the ratio of the velocity at the axis of the pipe to the mean velocity of flow in case of pipe flow under viscous condition ?

View solution

Q. Foot valve provided in the pump is a __________ valve.

View solution

Q. The discharge co-efficient for an orificemeter does not depend upon the

View solution

Q. If the head over the triangular notch is doubled, the discharge will increase by __________ times.

View solution

Q. Friction factor for a hydraulically smooth pipe at Nʀₑ = 2100 is f₁. If the pipe is further smoothened (i.e., roughness is reduced), the friction factor at the same value of Nʀₑ, will

View solution