Q. The maximum delivery pressure of a reciprocating compressor may be about __________ kg/cm².

View solution

Q. The velocity for subsonic flow in a pipeline

View solution

Q. Permanent pressure loss in a well designed venturimeter is about __________ percent of the venturi differential.

View solution

Q. Minimum fluidisation velocity for a specific system depends upon the

View solution

Q. Potential flow is characterised by the

View solution

Q. For the production of very high vacuum, a __________ pump is normally used.

View solution

Q. In parallel pipe problems, the

View solution

Q. Fluid flow through a packed bed is represented by the __________ equation.

View solution

Q. Major loss in sudden contraction in pipe flow is due to

View solution

Q. Which of the following can be used to create a flow of gas, where no significant compression is required ?

View solution

Q. The ratio of actual discharge to theoretical discharge through an orifice is equal to

View solution

Q. Cp/Cv is termed as

View solution

Q. The pump used for irrigation purposes is generally designed for

View solution

Q. In centrifugal pumps, cavitation occurs, when pressure of the impeller eye or vane becomes

View solution

Q. Pressure gradient in the pipe flow is influenced by the

View solution

Q. __________ pump is the most suitable device for discharging a liquid against a pressure of ≥ 1500 kgf/cm².

View solution

Q. Boiler feed water pump is usually a __________ pump.

View solution

Q. Forces acting on a particle settling in fluid are __________ forces.

View solution

Q. For a fluid rotating at constant angular velocity about vertical axis as a rigid body, the pressure intensity varies as the

View solution

Q. In a dry packed bed, the pressure drop will be changed by increasing the flow rate as

View solution