Question
a.
ε = ε₀ + α.t
b.
ε = ε₀ + α.t²
c.
ε = ε₀ + α.t³
d.
ε = ε₀ + α.t⁴
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following equations as suggested by Colebrook and White gives the increase in roughness of a new surface (ε₀) with age/time (t) (where, ε = roughness of the surface...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Fluidised beds are formed, when the
View solution
Q. A fluid is pumped at the rate of 10 lb/sec to a height of 55 ft. The horse power required is __________ hp.
View solution
Q. With increase in pump speed, its NPSH requirement
View solution
Q. In the Newton's law range, the terminal velocity of a solid spherical particle falling through a stationary fluid mass is __________ the fluid viscosity.
View solution
Q. Gear pump
View solution
Q. Most of the centrifugal pumps used in chemical plants are usually __________ driven.
View solution
Q. Check valve provided in the discharge line of a centrifugal pump serves the purpose of controlling the
View solution
Q. Which of the following two quantities when same, makes one pipe system equivalent to another pipe system ?
View solution
Q. The kinetic energy correction factor for velocity distribution of laminar flow is
View solution
Q. Priming of a centrifugal pump is done to
View solution
Q. Bed pressure drop in an air fluidised bed of catalyst particles (ρₚ = 200 kg/m³, Dₚ = 0.05 cm) of 60 cm bed depth and bed porosity of 0.5 expressed in cm of water (manometer) is
View solution
Q. For pipes that must be broken at intervals for maintenance, the connector used should be a/an
View solution
Q. Absolute viscosity of a fluid is a function of the __________ of the fluid.
View solution
Q. Select the wrong statement pertaining to flow of an incompressible fluid through a venturimeter.
View solution
Q. Reynolds number for water flow through a tube of I.D. 5 cm is 1500. If a liquid of 5 centipoise viscosity and 0.8 specific gravity flows in the same pipe at the same velocity, then the pressure drop will
View solution
Q. The bulk modulus of elasticity of a liquid
View solution
Q. Potential flow is the flow of
View solution
Q. The value of critical Reynolds number for pipe flow is
View solution
Q. Mach number is important in a fluid flow problem, when the inertia and __________ forces predominate.
View solution
Q. Fanning friction factor is equal to (where, fʙ = Blassius friction factor).
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
