Question
a.
jaw crushers
b.
ball mills
c.
compartment mills
d.
tube mills
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Basic slag is not ground in
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Grindability of a material does not depend upon its
View solution
Q. Shape factor for a cylinder whose length equals its diameter is
View solution
Q. In case of a hammer crusher, the
View solution
Q. Dust laden air can be purified using a
View solution
Q. Energy consumed for crushing one ton of material ranges from __________ kWh.
View solution
Q. For transporting pasty material, one will use a/an
View solution
Q. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a
View solution
Q. A tube mill compared to a ball mill
View solution
Q. Trommels separate a mixture of particles depending on their
View solution
Q. Size reduction does not occur due to compression in case of
View solution
Q. According to Taggart's rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than
View solution
Q. Which of the following represents the plot of filtrate volume versus time for constant pressure filtration ?
View solution
Q. Driving force in case of filtration by a centrifuge is the
View solution
Q. Rod mills employed for grinding
View solution
Q. A widely used size reduction equipment for __________ is Bradford breaker.
View solution
Q. Ultra centrifuges are used for the separation of __________ solid particles.
View solution
Q. Specific surface area is the surface area of a unit __________ of materials.
View solution
Q. A. __________ mill is a revolving mill divided into two or more sections by perforated partitions in which preliminary grinding takes place at one end and the finishing grinding at the discharge end.
View solution
Q. The constants (Kb, Kr and Kk) used in the laws of crushing (i.e., Bond's law, Rittinger's law and Kick's law) depend upon the
View solution
Q. __________ balls capable of grinding the feed in a ball mill gives the maximum efficiency.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
