Question

Use of 'grinding aids' is done in __________ grinding.

a.

dry

b.

wet

c.

ultrafine

d.

intermediate

Answer: (a).dry

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Use of 'grinding aids' is done in __________ grinding.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)

Q. Which of the following is the most suitable filter for separation of abrasive solids suspended in a corrosive liquid ?

Q. All resistances during washing of cake

Q. Ore concentration by jigging is based on the difference in the __________ of the particles.

Q. Size measurement of ultrafine particles can be best expressed in terms of

Q. Reduction ratio of crushers is the

Q. Which is a secondary crusher for a hard & tough stone ?

Q. Cyclones are used primarily for separating

Q. There is practically no alternative/competitor to __________ in the beneficiation treatment of sulphide ores.

Q. Separation of isotopes is generally done using a/an __________ centrifuge.

Q. Temperature of the product during ultrafine grinding

Q. Reciprocating screens are normally inclined at an angle of 5° with the horizontal and employ gyratory motion at feed end & reciprocating motion at the discharge end. They are not suitable for the screening of the

Q. Width and speed of a conveyor belt depends upon the __________ of the material.

Q. Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for

Q. Pick out the wrong statement.

Q. Which of the following size reduction equipments employs mainly attrition for ultrafine grinding ?

Q. Tank filter (e.g., Nutsch filter) is

Q. Which of the following gives the crushing energy required to create new surface ?

Q. In filtration, the use of 'filter aid' helps in

Q. Gizzlies are used for separating __________ solids.

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!