Q. Alphatron measures pressure __________ microns.

View solution

Q. What is the ratio of output amplitude to input amplitude for a sinusoidal forcing function in a first order system ?

View solution

Q. Which of the following controllers has maximum offset ?

View solution

Q. Pressure of 0.01 psi (absolute) can be measured by __________ gauge.

View solution

Q. High temperature of around 2000°C of incandescent gas mantles is measured by a/an

View solution

Q. The unit step response of the transfer function 1/(s² + 2s + 3)

View solution

Q. Number of poles in a system with transfer function 1 / (s²+2s²+1) is

View solution

Q. Radiation thermometer can not measure the temperature

View solution

Q. Temperature measurement by optical pyrometer is done above __________ point, which is 1063°C.

View solution

Q. Continuous flue gas analyser makes use of paramagnetic properties of some of its constituents, which move towards the strongest part of the magnetic field thus displacing diamagnetic gases. Which of the following gases is diamagnetic ?

View solution

Q. Dilatometer is used to measure

View solution

Q. The time constant of a unity gain, first order plus time delay process is 5 min. If the phase lag at a frequency of 0.2 rad/min is 60°, then the dead time (in minutes) is

View solution

Q. Which of the following does not figure in the list of seven substances selected for international temperature scale ?

View solution

Q. A constant volume gas thermometer employing __________ is used to measure sub-zero (i.e., < 0° C) temperature.

View solution

Q. pH meter has

View solution

Q. Routh test

View solution

Q. Bode diagram are generated from output response of the system subjected to which of the following input?

View solution

Q. Which of the following thermocouples is the most suitable for measuring a temperature of about 1600°C in an oxidizing atmosphere ?

View solution

Q. Mercury thermometer can be used to measure the temperature upto __________ °C.

View solution

Q. The transfer function of a process is 1 / (16s² + 8s + 4) . If a step change is introduced into the system, then the response will be

View solution