Question
a.
time required for the response of first reach its ultimate value is called the response time.
b.
overshoot (which is a measure of how much the response exceeds the ultimate value) increase with the decrease of damping co-efficient e.
c.
decay ratio (which is the ratio of the sizes of successive peaks) is equal to the reciprocal of overshoot.
d.
None of the above
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a second order under damped system, the
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In an exothermic chemical reactor, the manipulated variable is the flow rate of
View solution
Q. Very low pressure is expressed in microns(μ), which is equal to __________ mm of Hg coloumn (absolute) at 0°C.
View solution
Q. Which of the following is not a second order instrument ?
View solution
Q. Small furnace draught is accurately measured by an inclined tube manometer, in which the manometric liquid used most commonly is
View solution
Q. Specific conductance is defined as the reciprocal of resistance in ohms of 1c.c. of liquid at a specified temperature. Its value for distilled water is about __________ micro mho/cm³.
View solution
Q. A simple pitot tube measures the
View solution
Q. For a feed back control system to be stable, the
View solution
Q. __________ is the static characteristics of an instrument,
View solution
Q. Phase lag of the frequency response of a second order system to a sinusoidal forcing function
View solution
Q. Dead zone in an instrument must be less than __________ percent of the scale.
View solution
Q. Emission spectroscopy is used for
View solution
Q. A mercury thermometer can not be used to measure the temperature below the freezing point of mercury, which is __________ °C.
View solution
Q. __________ controller has the maximum stabilising time.
View solution
Q. Out of the following temperature measuring instruments, the measurement accuracy will be minimum for the
View solution
Q. Stalagmometer is used for the measurement of
View solution
Q. The deflection in diaphragm (which is used as pressure sensor in pneumatic and electronic instruments) is dependent on the metal thickness, its diameter (d) and shape & number of corrugations. Its deflection is proportional to
View solution
Q. Thermal conductivity cell is the primary element of a/an __________ analyser.
View solution
Q. Zirconia probe is used for the measurement of
View solution
Q. The root locus method, a pole of a transfer function G(s) is the value of s for which G(s) approaches
View solution
Q. __________ type of element is normally not used in the bimetallic thermometers.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
