Q. Higher furnace temperature can not be achieved by use of a lean fuel gas in the furnace by

View solution

Q. Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by

View solution

Q. Which of the following is a natural draft furnace ?

View solution

Q. To reduce the stack loss, heat recovery from flue gas can be done by

View solution

Q. Large tonnage of refractory bricks are dried in a

View solution

Q. Pulverised fuel fired furnaces employ __________ fuel firing.

View solution

Q. Which of the following is not a directly fired furnace ?

View solution

Q. Heat transfer rate to the stock/charge in the furnace does not depend upon the

View solution

Q. Power required in case of forced draught as compared to induced draught (for the same draught produced) is

View solution

Q. Means for giving direction to the circulation of gases in furnaces are

View solution

Q. The amount of combustible escaping uncon-sumed from the furnace, depends upon the

View solution

Q. Cement Kiln is a

View solution

Q. In a furnace employing forced draught as compared to induced draught,

View solution

Q. Regenerators are installed in

View solution

Q. Which of the following is a heat treatment furnace ?

View solution

Q. __________ atmosphere is maintained inside an iron blast furnace.

View solution

Q. In which of the waste heat recovery equipment, the flow of flue gas and air is alternately reversed after a fixed interval of time ?

View solution

Q. An electric furnace producing heat by means of an electric arc struck between each of three electrodes and the charge is called __________ furnace.

View solution

Q. Turndown ratio of a burner gives an idea of the __________ in the furnace.

View solution

Q. In low or standard frequency induction furnace, heat is produced by the

View solution