Q. The heating capacity of muffle furnace depends on the

View solution

Q. Which of the following is a batch furnace ?

View solution

Q. In a heating process, a heat flow diagram in which the quantities of heat in the various items of a heat balance are represented by the width of a band is called the

View solution

Q. Maximum thermal efficiency of boiler may be about __________ percent.

View solution

Q. Rotary kilns are used in the

View solution

Q. Thermal efficiency of furnaces can be improved by

View solution

Q. Shaft furnaces are used for

View solution

Q. Hearth furnaces are not used for

View solution

Q. Turn down ratio of a burner

View solution

Q. Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace ?

View solution

Q. Which is a regenerative furnace ?

View solution

Q. Which of the following accentuates clinker-ing troubles on furnace grate burning coal?

View solution

Q. The electric furnace in which heat is produced by a combination of induced current and skin effect is called __________ furnace.

View solution

Q. Ingress of cold air in the furnaces through cracks, charging doors, openings etc.

View solution

Q. Use of pulverised coal in boilers provides

View solution

Q. Regenerators are normally provided in the

View solution

Q. Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ °C, because corrosion prevails at higher temperatures.

View solution

Q. Furnace pressure is normally controlled by regulating the

View solution

Q. An example of indirectly heated furnace is the

View solution

Q. Specific heating capacity of a furnace is expressed as

View solution