Q. By plotting the C/t values obtained from a thermal death time curve, a curve is obtained. How is the lethal value obtained from this curve?

View solution

Q. Statement 1: In thermal death time curve, after plotting C/t values from it, C value should be equal to C₀ value.
Statement 2: When C₀ value versus process time in minutes is plotted on a linear graph paper, a straight line is obtained.

View solution

Q. With respect to thermal death time curve, D value is the unit defined as the combination of time and temperature to bring about a 90% reduction in spoilage organisms.

View solution

Q. Which of the following is required for calculation of process time by Ball’s method?

View solution

Q. Which of the following statements is true?

View solution

Q. When a CUT is 10 minutes and the calculated process was 60 minutes at 116 °C, then the corrected process time is _____

View solution

Q. Which of the following factor does safe processing schedule depend upon?

View solution

Q. For heat penetration considerations for safe processing schedule, the slowest cooling and the fastest heating curves are used to calculate lethal effect of the process.

View solution

Q. Statement 1: Which of the following methods is used to determine process times for products?
Statement 2: Which of the conditions is the above method used in?

View solution

Q. Statement 1: In low and medium acid foods, spore forming organisms are observed.
Statement 2: In acidic products, the organisms must be yeasts, molds etc.

View solution

Q. Statement 1: The swelling of cans takes place due to the release of hydrogen gas.
Statement 2: The swelling of cans takes place due to the release of carbon dioxide gas due to molasses and malt extracts.

View solution

Q. Statement 1: Corrosion of cans is more complicated than that of tin and iron alone. Depending on whether the tin forms a complex or not, it acts as the anode or cathode.
Statement 2: In the corrosion process, if hydrogen is not evolved, it exerts a back pressure and opposes further oxidation of iron.

View solution

Q. Statement 1: Glass packed food might be spoiled by light.
Statement 2: When canned foods with vacuum are taking onto flights, they _____

View solution

Q. Statement 1: Raising the temperature of the room by 10 °C will halve the storage life of that commodity.
Statement 2: Chemical reactions taking place during storage of canned foods will affect colour, texture and nutritive value of foods.

View solution

Q. Which of the following does the critical point in a canning operation vary with?

View solution

Q. Statement 1: The ingredients, mixing, filling, sealing and retorting are processes that are checked for safe and well carried out canning operations.
Statement 2: The heat processes, cooling, handling and recording are processes that are checked for safe and well carried out canning operations.

View solution

Q. Which of the following test does the seal of food item go through?

View solution

Q. Which of the following test should a retort pouch of food item pass through?

View solution

Q. Death rate in minutes of the bacteria at a particular temperature with respect to the formula by Stumbo is directly proportional to _____

View solution

Q. A lower z value means that the spores are _____ resistant to a given C value.

View solution