Q. Which of the following is usually adopted for contraction and construction joints?

View solution

Q. Which of the following is not a movement joint?

View solution

Q. A partial contraction joint is the one in which?

View solution

Q. Which of the following is a movement joint with deliberate discontinuity but no initial gap?

View solution

Q. Which of the following is a movement joint with complete discontinuity in both reinforcement and concrete and intended to accommodate either expansion or contraction of the structure?

View solution

Q. In reinforced concrete floors, the movement joints should normally be spaced at a maximum spacing of ____________

View solution

Q. The expansion joints in floors and walls should normally be provided at a spacing of not more than ___________

View solution

Q. What is the maximum expansion or contraction allowed for the joint filler material with an initial gap of about 30 mm?

View solution

Q. Which of the following can be used as support for an effective joint sealing compound in floor and floor joints?

View solution

Q. What provides a permanent watertight seal during the whole range of joint movement?

View solution

Q. Which of the following is sometimes used in expansion joints to avoid the risk of fault in an embedded water bar?

View solution

Q. Joint sealing compounds are impermeable ductile materials which are required to ___________________

View solution

Q. In case of the sealing joint, the lower part of the joint is occupied by joint filler.

View solution

Q. What is the most common metal used for water stops?

View solution

Q. The use of sealing compounds for vertical joints is very successful.

View solution