Question
a.
any drawdown
b.
a particular drawdown of 3 m
c.
the first 1 m of drawdown
d.
the first 2 m of drawdown
Posted under Irrigation Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The standard specific capacity of a well is the well-discharge per unit of drawdown. This value of discharge should be obtained at ________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. An example of aquitard stratum in the ground profile is a layer of ___________
View solution
Q. An aquifer which is confined at its bottom but not at the top is called ___________
View solution
Q. The clogging of well screens and consequent reduction in pump efficiency is indicated by _____________
View solution
Q. The rate of water contribution to the well increases with the increase in the depression head.
View solution
Q. The performance of a well is measured by its ________
View solution
Q. The safe depression head for open wells is generally taken to be x times the critical depression head when x is ______
View solution
Q. The yield of a well depends on ________________
View solution
Q. Which type of open well is suitable when the sub-soil is formed of gravel or coarse sand deposits?
View solution
Q. Depending upon the type of sub-soil formation, the construction of well is done in two ways i.e. Dug wells and Sunk wells. Dug wells are constructed in soft formations.
View solution
Q. A well 3 meters in diameter has its normal water level 3 meters below the ground level. By pumping water level in the well is depressed to 10 meters below the ground level. In 4 hours the water rises by 5 meters. Calculate the specific yield of the well.
View solution
Q. An open well is called shallow well when ____________
View solution
Q. Open well has big diameter than tube well because ____________
i. Open well has to irrigate more area.
ii. Water contribution to the well is natural and therefore, the percolation area has to be more.
iii. Storage of water has to be made before irrigation is done.
View solution
Q. If the sub-soil formation is of fine sand, the rough value of the specific yield of well per unit area of the well (K/A) given by Marriot is ____________
View solution
Q. Which of the following method of lifting water is very suitable when the depth of well is from 12 to 20 meters?
View solution
Q. Mota layer sometimes is also known as Marbarwa or Magasan is an impervious layer.
View solution
Q. A well is to be constructed in a fine sandy sub-soil formation. The discharge of the well under the depression head of 4 m is 0.004 m³/sec. Calculate the diameter of the well.
View solution
Q. The most widely used type of a deep state tube well in India is __________
View solution
Q. The general average yield from standard tube wells is of order of____________
View solution
Q. Which of the following tubewell is suitable when a deep bearing stratum lies below an impervious layer and water contribution can take place through bottom only?
View solution
Q. In cavity tubewell, there is a possibility of water tapping through sides and the flow is radial.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Irrigation Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!