Question
a.
the depth of well is small
b.
the water table is high
c.
it does not encounter mota formation
d.
it finds the foundation in the mota formation
Posted under Irrigation Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. An open well is called shallow well when ____________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Open well has big diameter than tube well because ____________
i. Open well has to irrigate more area.
ii. Water contribution to the well is natural and therefore, the percolation area has to be more.
iii. Storage of water has to be made before irrigation is done.
View solution
Q. If the sub-soil formation is of fine sand, the rough value of the specific yield of well per unit area of the well (K/A) given by Marriot is ____________
View solution
Q. Which of the following method of lifting water is very suitable when the depth of well is from 12 to 20 meters?
View solution
Q. Mota layer sometimes is also known as Marbarwa or Magasan is an impervious layer.
View solution
Q. A well is to be constructed in a fine sandy sub-soil formation. The discharge of the well under the depression head of 4 m is 0.004 m³/sec. Calculate the diameter of the well.
View solution
Q. The most widely used type of a deep state tube well in India is __________
View solution
Q. The general average yield from standard tube wells is of order of____________
View solution
Q. Which of the following tubewell is suitable when a deep bearing stratum lies below an impervious layer and water contribution can take place through bottom only?
View solution
Q. In cavity tubewell, there is a possibility of water tapping through sides and the flow is radial.
View solution
Q. What is the measure of the fineness of an aquifer?
View solution
Q. What is Pack Aquifer Ratio?
View solution
Q. According to the Central Board of Irrigation and Power, the PA ratio for graded aquifer should be _______________
View solution
Q. For good design, the uniformity coefficient (Cᵤ) of the gravel material should preferably be ______
View solution
Q. The efficiency of the centrifugal pumps commonly used for lifting water from wells may be of the order of _____________
View solution
Q. A tube well is suitable when the subsoil formation is made up of _____________________
View solution
Q. Bored tube wells in rocky consolidated formations as are encountered in the South Indian States of our country are usually drilled by _____________
View solution
Q. Which of the following drilling method is unsuitable in loose formations such as unconsolidated sand and gravel or quicksand?
View solution
Q. Which drilling method is best suited for underground formations made of gravel, sand and clayey deposits?
View solution
Q. Which is the fastest method of drilling and especially useful in unconsolidated formations?
View solution
Q. A household tube well is called Abyssinian tube well falls under _________
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Irrigation Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!