Q. What is the approximate percentage of light reinforcement that is provided in the top of the reinforced concrete slabs at the base?

View solution

Q. A shaft spillway is located _______________________

View solution

Q. The siphons installed within a gravity dam to spill the surplus reservoir water are known as ______________________

View solution

Q. The siphons installed over overflow dams constitute what are known as __________________

View solution

Q. The only spillway among the following through which the discharge does not increase as fast as it increases in all others is _________________

View solution

Q. The only spillway among the following through which the discharge is almost at its capacity rate even from the start of its functioning is ________________

View solution

Q. An air vent is provided at FRL to break the siphoning action at that level in a ___________________

View solution

Q. Which of the following spillway is designed in India by Ganesh Iyer?

View solution

Q. The crest of a siphon spillway is fixed at ________________

View solution

Q. A siphon spillway is sufficiently independent of the water surface elevation of the reservoir.

View solution

Q. The allowable maximum negative head on an average is equal to __________

View solution

Q. The structure which is not used in a shaft spillway is ________________

View solution

Q. Morning glory is the _____________________________

View solution

Q. For a saddle siphon, the maximum operative head is 4.53 m. The width and height of the throat of the siphon are 5 m and 2.25 m respectively. The coefficient of discharge is 0.90. How many units are required to pass a flood of 350 cumecs? (Assume g = 10 m/s2)

View solution

Q. A siphon spillway in a concrete gravity dam is in the shape of ________________

View solution

Q. The energy dissipation at the toe of the spillway is affected basically by the use of hydraulic jump in _______________________

View solution

Q. The most ideal condition for energy dissipation in the design of spillways is the one when the tail-water rating curve coincides with the jump rating curve at all discharge.

View solution

Q. When the tail-water depths in the river downstream of a spillway are quite low such that the tail-water curve at all discharges lies below the post jump depth curve, then the energy dissipation can be affected best by ___________________

View solution

Q. The device which does not help in energy dissipation at the bottom of a hydraulic structure over which water spills is ________________

View solution

Q. The formation of hydraulic jump at the foot of a spillway is one of the common methods of energy dissipation because ______________________

View solution