Question

The depth of water stored in an irrigation tank rarely exceeds ______________

a.

4 m

b.

8 m

c.

12 m

d.

16 m

Posted under Irrigation Engineering

Answer: (c).12 m

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The depth of water stored in an irrigation tank rarely exceeds ______________

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The storage created on the upstream side of a smaller stream by the construction of low earthen bunds is technically known as _________________

Q. The provision of suitable breaching sections becomes more important in irrigation tanks which are isolated.

Q. The cubic meters of water that can be stored in an irrigation tank between full tank level and sill level of the lowest supply sluice is known as __________________

Q. If A₁ represents the area of a tank bed at bottom and A₂ is the area of the tank at F.T.L, then the storage capacity of the tank of height H is given as ________________________

Q. The top-level of a tank weir in a tank bund scheme is kept at ________

Q. The usual arrangement made in a tank-bund scheme to spill the surplus excess water is known as ________________________

Q. If A₁ and A₂ represent the areas enclosed between two successive contours, then the cubic content between these contours is roughly taken as _________________

Q. The most adopted earthen section for tank bunds is of the type ___________________

Q. What is the approximate value of side slope of the bund for smaller tanks with water depths not exceeding 2.5 m in favorable soils such as red and white gravel, red and black loams?

Q. The usual difference between F.T.L and M.T.L is rarely allowed to exceed _____________

Q. Which of the following type of tank weirs are provided with a number of vertical steps instead of horizontal or sloping downstream apron?

Q. The width of the horizontal floors of type A and D weirs from the foot of the drop wall to the d/s edge of the floor should never be less than ________________

Q. Which among the following is a correct representation of Ryve’s formula?

Q. The capacity of an irrigation tank is sometimes increased by installing a temporary stone wall over the top of the tank weir. This fixture is known as____________________

Q. The discharge through the sluice of a small irrigation tank is usually controlled by _______________

Q. What will the discharging capacity of a masonry waste weir of 55 m length and 1.5 m width provided in an earthen bund for passing a flood with 1.2 m water depth over its crest?

Q. Pipe sluices are generally not adopted in tank bunds where the depth below F.T.L exceeds ____________

Q. Calculate peak discharge for a combined catchment of a tank forming a constituent unit of a group with the following given data –

Combined catchment = 26 sq. km
Intercepted catchment = 20 sq. km
Ryve’s coefficient for combined catchment = 9.0
Ryve’s coefficient intercepted = 1.8

Q. What is the approximate value of Ryve’s coefficient for combined catchment having limited areas near hills?

Recommended Subjects

Are you eager to expand your knowledge beyond Irrigation Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!