Question
a.
120 cumecs
b.
254 cumecs
c.
59.4 cumecs
d.
65.8 cumecs
Posted under Irrigation Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. What will the discharging capacity of a masonry waste weir of 55 m length and 1.5 m width provided in an earthen bund for passing a flood with 1.2 m water depth over its crest?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The discharge through the sluice of a small irrigation tank is usually controlled by _______________
View solution
Q. The capacity of an irrigation tank is sometimes increased by installing a temporary stone wall over the top of the tank weir. This fixture is known as____________________
View solution
Q. Which among the following is a correct representation of Ryve’s formula?
View solution
Q. The width of the horizontal floors of type A and D weirs from the foot of the drop wall to the d/s edge of the floor should never be less than ________________
View solution
Q. Which of the following type of tank weirs are provided with a number of vertical steps instead of horizontal or sloping downstream apron?
View solution
Q. The usual difference between F.T.L and M.T.L is rarely allowed to exceed _____________
View solution
Q. What is the approximate value of side slope of the bund for smaller tanks with water depths not exceeding 2.5 m in favorable soils such as red and white gravel, red and black loams?
View solution
Q. The most adopted earthen section for tank bunds is of the type ___________________
View solution
Q. If A₁ and A₂ represent the areas enclosed between two successive contours, then the cubic content between these contours is roughly taken as _________________
View solution
Q. The usual arrangement made in a tank-bund scheme to spill the surplus excess water is known as ________________________
View solution
Q. The top-level of a tank weir in a tank bund scheme is kept at ________
View solution
Q. If A₁ represents the area of a tank bed at bottom and A₂ is the area of the tank at F.T.L, then the storage capacity of the tank of height H is given as ________________________
View solution
Q. The cubic meters of water that can be stored in an irrigation tank between full tank level and sill level of the lowest supply sluice is known as __________________
View solution
Q. The provision of suitable breaching sections becomes more important in irrigation tanks which are isolated.
View solution
Q. The storage created on the upstream side of a smaller stream by the construction of low earthen bunds is technically known as _________________
View solution
Q. The depth of water stored in an irrigation tank rarely exceeds ______________
View solution
Q. The fuel consumption in water transport decreases as the depth of water between the bottom of the ship and the bottom of the river increases.
View solution
Q. Which of the following dredger is not suitable for rocky or boulder river reaches?
View solution
Q. The rivers carrying huge sediment load can be corrected with the help of sal-balli spurs.
View solution
Q. The alignment of the waterway should be________________
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Irrigation Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!