Q. Which test is conducted to measure the ability of a material to resist scratching, abrasion, deformation and indentation?

View solution

Q. Which test is conducted to measure the endurance limit of the material?

View solution

Q. What is the process in which the metal is cooled rapidly in water after heating the metal above the lower critical temperature to increase the hardness of the material?

View solution

Q. What is the process of heating the metal in the furnance to a temperature slightly above the upper critical temperature and cooling slowly In the furnance.

View solution

Q. Photo stress method is ___________

View solution

Q. What is the factor of safety?

View solution

Q. Which one of the following has the largest value of thermal coefficient?

View solution

Q. Identify which factor may cause a lowered body temperature:

View solution

Q. If a bar of two different length are in a line and P load is acting axially on them then what will be the change in length of the bar if the radius of both different lengths is same?

View solution

Q. If a bar of two sections of different diameters of same length are in a line and P load is acting axially on them then what will be the change in length of the bar?

View solution

Q. Does the value of stress in each section of a composite bar is constant or not?

View solution

Q. A composite bar of two sections of equal length and equal diameter is under an axial pull of 10kN. What will be the stresses in the two sections?

View solution

Q. A composite bar of two sections of unequal length and equal diameter is under an axial pull of 10kN. What will be the stresses in the two sections?

View solution

Q. A composite bar of two sections of equal length and given diameter is under an axial pull of 15kN. What will be the stresses in the two sections in N/mm²?

View solution

Q. Which law states the when a number of loads are acting on a body, the resulting strain, according to principle of superposition, will be the algebraic sum of strains caused by individual loads?

View solution

Q. How the total strain in any body subjected to different loads at different sections can be calculated?

View solution

Q. Three sections in a beam are of equal length of 100mm. All three sections are pulled axially with 50kN and due to it elongated by 0.2mm. What will be the resultant strain in the beam?

View solution

Q. Two sections in a bar of length 10cm and 20cm respectively are pulled axially. It causes an elongation of 0.2mm and 0.4mm respectively in each section. What will be the resultant strain in the bar?

View solution

Q. A composite bar have four sections each of length 100mm, 150mm, 200mm, 250mm. When force is applied, all the sections causes an elongation of 0.1mm. What will the resultant strain in the bar?

View solution

Q. A brass bar, having cross sectional area of 100mm², is subjected to axial force of 50kN. The length of two sections is 100mm and 200mm respectively. What will be the total elongation of bar if E = 1.05 x 10⁵ N/mm² ?

View solution