Q. Which of the following is indeterminate structure?

View solution

Q. ____________ is used to produce due to temperature variation in indeterminate structures.

View solution

Q. In cantilever beams, the maximum deflection occurs at ___________

View solution

Q. As per IRC, maximum width of lane considered as ____________

View solution

Q. ______ is the area of land acquired and reserved for future development.

View solution

Q. Stability of high rise vehicles will be affected due to ____________

View solution

Q. The longitudinal rise or fall off road surface along its length is _________

View solution

Q. Which of the following gradient is usually used in the construction of roads?

View solution

Q. According to IRC, the height of the object is taken to the height of ___________ mm.

View solution

Q. What is the minimum shoulder width provided for village roads?

View solution

Q. In case of vertical curves, the ____________ are taken above the road.

View solution

Q. The time required for overtaking ___________ seconds.

View solution

Q. _____ provide gradual introduction of super elevation.

View solution

Q. The upward deflection caused by the prop is _____________

View solution

Q. Stiffness of the propped cantilever is _________

View solution

Q. The major losses of energy due to friction are calculated by using _________

View solution

Q. The ratio of A/P is ___________

View solution

Q. Determine the velocity of flow in a pipe if the discharge capacity is 270 litres per second and cross sectional area is 5 cm².

View solution

Q. Calculate the reaction at prop of cantilever, if the span of beam is 5m and load is 20 kN.

View solution

Q. The highest point on syphon is known as ____

View solution