Q. A 250 mm by 250 mm ingot casting, 1.5 m high and at 1225 K temperature, is stripped from its mold. The casting is made to stand on end on the floor of a large foundry whose wall, floor and roof can be assumed to be at 300 K temperature. Make calculation for the rate of radiant heat interchange between the casting and the room. The casting material has an emissivity of 0.85

View solution

Q. Interchange factor for infinitely long concentric cylinders is given by

View solution

Q. What is the geometric factor for infinitely long concentric cylinders?

View solution

Q. What is the geometric factor for concentric spheres?

View solution

Q. The net heat interchange between non-black bodies at temperature T 1 and T 2 is given by

View solution

Q. A thermos flask has a double walled bottle and the space between the walls is evacuated so as to reduce the heat flow. The bottle surfaces are silver plated and the emissivity of each surface is 0.025. If the contents of the bottle are at 375 K and temperature of ambient air is 300 K. What thickness of cork (k = 0.03 W/m degree) would be required if the same insulating effect is to be achieved by the use of cork?

View solution

Q. The total radiant energy leaving a surface per unit time per unit surface area is represented by

View solution

Q. Determine the radiant heat flux between two closely spaced, black parallel plates radiating only to each other if their temperatures are 850 K and 425 K. The plates have an area of 4 m²

View solution

Q. What is the value of grey body factor for concentric cylinders?

View solution

Q. The net rate at which the radiation leaves the surface is given by

View solution

Q. A ring (E = 0.85) of 8 cm inner and 16 cm outer diameter is placed in a horizontal plane. A small element (E = 0.7) of 1 cm² is placed concentrically 8 cm vertically below the center of the ring. The temperature of the ring is 800 K and that of small area is 400 K. Find the radiant heat gain by the small ring

View solution

Q. Two opposed, parallel, infinite planes are maintained at 420 K and 480 K. Calculate the net heat flux between these planes if one has an emissivity of 0.8 and other an emissivity of 0.7

View solution

Q. The total radiant energy incident upon a surface per unit time per unit area is known as

View solution

Q. Which one of the following is true for opaque non-black surface?

View solution

Q. A radiation shield should

View solution

Q. Radiation shield are used between the emitting surfaces such that

View solution

Q. Which of the following can be used as a radiating shield?

View solution

Q. Determine the net radiant heat exchange per m 2 area for two infinite parallel plates held at temperature of 800 K and 500 K. Take emissivity as 0.6 for the hot plate and 0.4 for the cold plate

View solution

Q. Two parallel square plates, each 4 m² area, are large compared to a gap of 5 mm separating them. One plate has a temperature of 800 K and surface emissivity of 0.6, while the other has a temperature of 300 K and surface emissivity of 0.9. Find the net energy exchange by radiations between the plates

View solution

Q. The furnace of a boiler is laid from fire clay brick with outside lagging from the plate steel, the distance between the two is quite small compared with the size of the furnace. The brick setting is at an average temperature of 365 K whilst the steel lagging is at 290 K. Calculate the radiant heat flux. Assume the following emissivity values

For brick = 0.85
For steel = 0.65

View solution