Q. In a food processing plant, a brine solution is heated from – 12 degree Celsius to – 65 degree Celsius in a double pipe parallel flow heat exchanger by water entering at 35 degree Celsius and leaving at 20.5 degree Celsius. Let the rate of flow is 9 kg/min. Estimate the area of heat exchanger for an overall heat transfer coefficient of 860 W/m² K. For water c P = 4.186 * 10³ J/kg K

View solution

Q. Exhaust gases (c P = 1.12 k J/kg K) flowing through a tubular heat exchanger at the rate of 1200 kg/hr are cooled from 400 degree Celsius to 120 degree Celsius. This cooling is affected by water (c P = 4.18 k J/kg K) that enters the system at 10 degree Celsius at the rate of 1500 kg/hr. If the overall heat transfer coefficient is 500 k J/m² hr degree, what heat exchanger area is required to handle the load for parallel flow arrangement?

View solution

Q. A steam condenser is transferring 250 k W of thermal energy at a condensing temperature of 65 degree Celsius. The cooling water enters the condenser at 20 degree Celsius with a flow rate of 7500 kg/hr. Calculate the log mean temperature difference

View solution

Q. For what value of end temperature difference ratio, is the arithmetic mean temperature difference 5% higher than the log-mean temperature difference?

View solution

Q. A company is heating a gas by passing it through a pipe with steam condensing on the outside. What percentage change in length would be needed if it is proposed to triple the heating capacity?

View solution

Q. A steam condenser is transferring 250 k W of thermal energy at a condensing temperature of 65 degree Celsius. The cooling water enters the condenser at 20 degree Celsius with a flow rate of 7500 kg/hr. If overall heat transfer coefficient for the condenser surface is 1250 W/m² K, what surface area is required to handle this load?

View solution

Q. Exhaust gases (c P = 1.12 k J/kg K) flowing through a tubular heat exchanger at the rate of 1200 kg/hr are cooled from 400 degree Celsius to 120 degree Celsius. This cooling is affected by water (c P = 4.18 k J/kg K) that enters the system at 10 degree Celsius at the rate of 1500 kg/hr. If the overall heat transfer coefficient is 500 k J/m² hr degree, what heat exchanger area is required to handle the load for counter flow arrangement?

View solution

Q. What is the value of specific heat for brick in J/kg K?

View solution

Q. Which one is having highest value of specific heat?

View solution

Q. What is the value of specific heat for asphalt in J/kg K?

View solution

Q. What is the value of specific heat for Bakelite in J/kg K?

View solution

Q. Which one is having lowest value of specific heat?

View solution

Q. What is the value of specific heat for coal in J/kg K?

View solution

Q. What is the value of specific heat for cotton in J/kg K?

View solution

Q. What is the value of specific heat for sand in J/kg K?

View solution

Q. Which one is having highest value of overall heat transfer coefficient?

View solution

Q. What is the value of overall heat transfer coefficient for air to heavy tars and liquid?

View solution

Q. What is the value of overall heat transfer coefficient for air to low viscosity liquid?

View solution

Q. Which one is having lowest value of overall heat transfer coefficient?

View solution

Q. What is the value of overall heat transfer coefficient for air condensers?

View solution