Question
a.
2.0
b.
1.5
c.
0.5
d.
4.0
Posted under Foundation Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For the design of gravity dam, the minimum value of F(factor of safety) against sliding should be __________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Positive projecting conduits are of ___________ types.
View solution
Q. The settlement ratio for a negative projecting conduit is __________
View solution
Q. The magnitude and direction of relative movements between the interior and exterior prisms of the conduits are dependent upon the ___________
View solution
Q. Critical plane in conduit is located at ___________
View solution
Q. If the critical plane settles more than the top of the conduit, the settlement ratio is __________
View solution
Q. Both the projection condition and the ditch conditions of a positive projecting conduit may be __________
View solution
Q. If the plane of settlement does not fall within the embankment, then such a condition is called _________
View solution
Q. The sign used for complete projection is __________
View solution
Q. The recommended value of settlement ratio for embankment, to use in design is __________
View solution
Q. The load on a negative conduit is given by the equation __________
View solution
Q. A soil engineers usually encounter problems of stress distribution in __________
View solution
Q. The problem of stress distribution in the vicinity of shafts was first solved by ________
View solution
Q. The method given by Biot for solving the problem of stress distribution was based on ________
View solution
Q. The stress component which acts on any point in the surrounding material before the excavation of the shaft can be resolved into __________ parts.
View solution
Q. Stress due to equivalent fluid pressure can be found out using __________
View solution
Q. After excavating the shaft, the shearing stresses along the walls of the shaft will be equal to ___________
View solution
Q. When the high value of σϴ in the vicinity of the walls of a shaft exceeds the compressive strength it results in __________
View solution
Q. The stress component at any point, after the excavation of the shaft, will be equal to ____________
View solution
Q. Underground conduits are commonly used for, which of the following purpose?
View solution
Q. A ditch conduits can be installed in a __________
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Foundation Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!